Features of twist drill and its influence on cutting

HSS Taper Shank Twist Drill  3

(1) The diameter of  high-speed-steel twist drill twist drill can be influenced by the aperture, spiral grooves make it be more detailed core drilling, drill rigidity is lower. There are only two edge band guidelines, hole&rsquo s axis are easily skew It’srsquo s difficult to make a centering because of chisel, axial resistance increases, drill is easy to swing. Therefore, drilled hole has the low accuracy.
(2) Both the rake face and flank face of the twist are curved, each point along the main cutting edge’s rake angle and bank angle varies, the rake angle of the chisel edge is -55 ° . Cutting conditions are very poor cutting along the cutting edge distribution is unreasonable, the lowest intensity has the maximum cutting tip, so it was badly worn. Thus, the hole machining accuracy is low.
(3) The main drill cutting edge participate cutting fully, each point on the cutting edge isn’ t equal, it’ s easy to form a spiral-shaped chip and difficult to remove chip . Therefore, chips and the hole wall always have friction and extrusion, often scratching the hole wall, and the surface roughness after machining is low.

Stay tuned for detailed product information company official website: http://www.langfengmetallic.com/

Be the first to comment on "Features of twist drill and its influence on cutting"

Leave a comment

Your email address will not be published.